HW 30 Amp ESC
• Compact 30 amp Brushless ESC
• 5V 2A BEC
• 35 amps continuous,
• Programmable Features
• Compatible with the HW program card

programmable features:
-Brake: enabled or disabled (disabled default)
-Battery type: Li-Po or Ni-xx (Li-Po default)
-Low Voltage Cut off type: soft or hard (soft default)
-LVC setting, Low, Med, High: (Li-Po - L 2.6V,M 2.85V,H 3.1V)(Ni-xx - L disabled,M 45%,H 60%)(medium default)
-Startup mode: normal, soft, super soft (normal default)
-Timing: Low, med, high (Low 2-4poles, Med 6-10 poles, high 12+ poles) (medium default)
-Compatible with HW program card.

 Click here for the HW program card
(recommended)

If you are not familiar with the Hobby Wing Programming procedure or you do not have a Hobby Wing or Hobby Wing compatible programming card, to use these ESC's in the simplest mode possible, that will be auto Li-Po, and No-Brake you will need to use the following procedure to teach the ESC your throttle end points before it will operate.  To set end points (only needed before first use or change of transmitter).

1. Power on transmitter, set throttle to full 100%.
2. With motor/esc connected, Power on receiver, wait for confirmation tone from ESC.
3. Set throttle to off 0%.  Wait for confirmation tone.

You may now power everything down and use as normal.  Please use caution during this as any programming proceduce with an ESC incase of accidental motor start.